What are the steps of using the Nonwoven Geotextile?

The function of Nonwoven Geotextile is to isolate building materials (such as soil and sand, soil and concrete) with different physical properties (particle size, distribution, consistency and density, etc.). Make sure that two or more materials are not lost or mixed, maintain the overall structure and function of the materials, and strengthen the load-bearing capacity of the structure.

What are the characteristics of Nonwoven Geotextile?

What are the precautions for the use of Nonwoven Geotextile?

What should be paid attention to after laying of Nonwoven Geotextile?

What are the characteristics of Nonwoven Geotextile?

The Nonwoven Geotextiles have good water conductivity. It can form a drainage channel in the soil to drain excess fluid and gas into the soil structure. The Nonwoven Geotextile is used to increase the tensile strength and deformation resistance of the soil, increase the stability of the building structure and improve the quality of the soil. Distribute, transfer or decompose the concentrated load effectively to prevent damage to the soil by external force. Prevent mixing between upper and lower sand, soil and concrete. The network is not easy to block and the network structure made of amorphous fibrous fabric has stretching and mobility. High water permeability can also maintain good water permeability under the pressure of soil and water. Corrosion resistance, acid and lye resistance, no moth, oxidation resistance, simple construction and high efficiency.

What are the precautions for the use of Nonwoven Geotextile?

1. Nonwoven Geotextile can only be cut with geotextile knife (hook knife). When cut at the site, special protective measures must be taken for other materials to avoid unnecessary damage by cutting geotextiles;

2. While laying Nonwoven Geotextile, all necessary measures must be taken to prevent damage to the lower layer of materials;

3. When laying the nonwoven geotexture, care must be taken not to let the stone, a large amount of dust or moisture that may damage the nonwoven geotexture, block the drainage channel or filter screen, or make it difficult for the next connection enter the inner surface.

What should be paid attention to after laying of Nonwoven Geotextile?

1. After installation, visually inspect all non woven geotexture surfaces to determine the location of all damage, mark and repair them, and ensure that the laying surface is free of foreign substances that can cause damage, such as broken needles and other foreign substances;

2. The connection of nonwoven geotexture must comply with the following regulations: under normal circumstances, there can be no horizontal connection on the slope (the connection must not intersect with it along the contour of the slope), except where it is repaired.

3. If suture is used, the suture must be made of the same or more than geotextile material, and the suture must be chemical ultraviolet resistant material. There shall be obvious color difference between suture and Nonwoven Geotextile for inspection.

4. Pay special attention to stitching during installation to ensure that no gravel in soil or gravel overburden enters the middle of Nonwoven Geotextile.

Feicheng Lianyi Plastic Co., Ltd. has various Nonwoven Geotextiles that can provide the increasing of products, and make them more effective, reliable, and consistent.